FSX Brisbane International Airport Scenery

Brisbane International Airport (YBBN), Australia, v2. Includes two versions, one with the crosswind runway operating and one without. Also includes assigned parking, support vehicle roads, extra fuel trucks and other improvements. By Ray Smith.

ADE Home Edition (Freeware) was used to design these BGL files: This is an update of my previous version, my previous version not required, these 2 files are only for the FSX default airport: one with the Xwind rwy 14/32 activated where Both rwy's will be used for takeoff/landing and one as default: assigned parking with extra parking, support vehicle roads rebuilt, extra fuel trucks and several other improvements, airport views are from the roof of the control tower (when in tower view) fully tested with Ultimate Traffic/WOAI but not required, please view the readme before installation

There are 2 BGL files: YBBN_ADE_RS.BGL and YBBN_ADE_CW_RS.BGL

The 'YBBN_ADE_CW_RS.BGL' version is with the Xwind rwy activated, the other version YBBN_ADE_RS.BGLis without parking is the same in both......

NOTE: PLEASE ONLY USE ONE BGL FILE AT A TIME:
ie: make sure there is only ONE 'YBBN.BGL' FILE in the Addon Scenery/scenery folder at any time, remove/delete any other YBBN.bgl

PLEASE NOTE: when using ATIS with the YBBN_ADE_CW_RS.BGL file you will hear the fake rwy's, this is the method used in activating Xwind rwy's created by Jim Vile and should be ignored or if prefered use the version YBBN_ADE_RS.BGL

To Install:

1. simply take the BGL file of your choice and place it into: Flight Simulator X/Addon Scenery/scenery folder.

2. Start up the Flight sim and the changes will be present.

To Uninstall:

1. Delete the BGL file and the default will then be active.

TIP: when at YBBN in tower view: go to your control settings and look for the "View track/pan Toggle" allocate a keyboard key stroke to it (i allocated a button on my X52 controller) this will unlock the user aircraft, then you can use the hat switch to pan 360 degrees around the airport, hitting the key stroke again (in my case a button) will return you to the user aircraft position

Enjoy and happy flying.

Ray

Leave a comment