FSX Shorts SD3-60 Twin Turboprop

Shorts SD3-60 twin turboprop STOL short/medium range freighter. Full package for FSX/SP2 with custom panel, VC, full cabin modelling, sounds, check and ref lists. Two liveries, Skyway Aviation and Roblex Aviation. This is the cargo version with a little animated load/unload sequence triggered by the wing fold command. By Jean-Pierre Brisard, Barry Blaisdell and Bob May - Premier Aircraft Design.

PACKAGE INSTALLATION FS9 and FSX:

Extract all files into the FS9 or FSX MAIN Folder using WINZIP in Classic Mode...Do not use the Wizard...Make sure the "Use Folder names" BOX is checked in WINZIP. New folders will be created and all files installed.

Here's how by the numbers...

1. Navigate to where you downloaded the zip file.

2. Double click with your mouse on the zip file.

3. WINZIP should Open and show all the files inside the zip.

4. Press 'CTRL A' and this will select all the files.

5. Click on upper 'Extract' Button in the Main Tool Bar above.

6. Type in your path to FS9 or FSX in the pop-up dialog box or browse to your FS9/FSX Location...

The normal locations are:
FS9 C:/program files/microsoft games/flight simulator 9.
FSX C:/program files/microsoft games/microsoft flight simulator X.

7. Now Click on the 'Extract' button in the upper right.....you're done...go flying.

OPERATING TIPS

*Turn on Tool Tips....Lots of panel information available. Go to Options - Settings - General....Click the "Show Tool Tips" box.)

SHIFT E opens/closes the passenger door, there is no separate crew door.

SHIFT E 2 opens/closes the the baggage and cargo doors. Note, on passenger versions the large cargo door does not open.

NOTE: No doors will open in flight.

Shift-W toggles the yoke on/off in VC panel (Ctrl-W in FSX).

To Raise your seat higher press SHIFT-ENTER (in FSX this only works in VC view).

The spinning props look better in flight if you dab Ctrl-F2 a few times.

CARGO VERSION ONLY:

Wing fold command (USUALLY SHIFT K) starts and stops a short load/unload animation. The big cargo door must be open to see this.

Quick Reference - VC EYEPOINT KEY COMMANDS :

Move eyepoint back into passenger cabin
CTRL+ENTER (press and hold)

Move Eyepoint Down
SHIFT+BACKSPACE

Move Eyepoint Forward
CTRL+BACKSPACE

Move Eyepoint Left
CTRL+SHIFT+BACKSPACE

Move Eyepoint Right
CTRL+SHIFT+ENTER

Move Eyepoint Up
SHIFT+ENTER

Reset Eyepoint
SPACE