FSX Lockheed L-1011 Engine Smoke

Lockheed L-1011 Engine Smoke. Engine smoke coordinates for the FS2004 freeware Erick Cantu Lockheed L-1011-100 when used in FSX. Easy installation. By Tom Tiedman.

DESCRIPTION:

engine smoke coordinates for the FS2004
freeware Erick Cantu Lockheed L-1011-100
when used in FSX. Easy installation.
By Tom Tiedman

CREDITS: Erick Cantu for his Lockheed L-1011-100.

Smoke coordinates by
Tom Tiedman

INSTALLATION: Simple as 1, 2, 3...

1.) Open your L-1011 "aircraft.cfg" file,
copy and paste the [SMOKESYSTEM] info.
below into the aircraft.cfg file.
I pasted mine at the bottom with good results.
Then click 'file', then click 'save', of course.

2.) Notice the coordinates show the "fx_smoke_f6"
effect as the one I'm using, and chances are
if you have any of my other smokes, then the
"fx_smoke_f6" effect file is already located in
your FSX "Effects" folder. If you wish to use a
different smoke effect from your FSX "Effects"
folder, simply rename the 3 "fx_smoke_f6" info. in
the coordinates to the name of the smoke effect
of your choice, then click 'file', then click 'save',
of course.

3.) This aircraft was large enough for me to hide the
smoke inside of the engines, so you need only press
your "I" key once at the start of the flight. As you
begin to roll, the smoke will start pouring out of the
engines. After you land and roll to a stop, the smoke
will disappear back inside the engines. As you start
to roll again, the smoke will begin to pour out from
the engines again.

[SMOKESYSTEM]
smoke.0=1.232, -35.416, -3.501, fx_smoke_f6
smoke.1=-80.732, 0.401, 9.901, fx_smoke_f6
smoke.2=1.232, 35.816, -3.501, fx_smoke_f6