Remove green guidance lines in MSFS 2020 helicopters by disabling the right Navigation Aids setting, plus fixes if the overlay returns.
In Microsoft Flight Simulator 2020, open Options > Assistance Options, expand Navigation Aids, and switch off Route & Waypoints and Landing Path. Disable Taxi Ribbon as well if the line appears on the ground. Apply and save the changes. These are visual-assistance overlays, not part of the helicopter's flight model.
Which setting removes each green line?
The correct switch depends on where the guidance appears and what shape it takes. Colours can vary with the activity and display settings, so use the line's position rather than colour alone.
| What you see | Setting to disable |
|---|---|
| A line or markers leading towards a waypoint | Route & Waypoints |
| Gates or a descending path near the destination | Landing Path |
| A ribbon or arrows over the ground | Taxi Ribbon |
| Numerous fine lines flowing around the rotor or airframe | An aerodynamic debug visualisation in Developer Mode |
Our guide to finding and changing MSFS navigation-assistance switches explains the related marker and guidance options.
How do I hide the lines without disabling helicopter assists?
- Pause the flight and open
Options > Assistance Options. - Expand Navigation Aids rather than selecting a different assistance preset, which would change unrelated flying aids.
- Turn off the relevant overlay. Start with Route & Waypoints for an airborne line, then Landing Path if it appears during an approach.
- Leave helicopter handling aids alone unless you also want to change how the aircraft flies.
- Apply and save, then return to the flight. The overall assistance preset may change to Custom; that is expected after editing individual switches.
If you want to remove labels, markers and other screen furniture as well, use our breakdown of the MSFS 2020 interface and overlay controls.
Why does the green guidance line come back?
A saved assistance preset or activity-specific objective can restore guidance that was previously hidden.
- Preset changed: Selecting an easy or all-assistance preset can enable Navigation Aids again. Recheck the individual switches afterwards.
- Training or activity guidance: Some structured activities display their own objectives. Test the same helicopter in a normal free flight; if the line disappears there, it belongs to the activity.
- Changes were not saved: Use Apply and Save before leaving Assistance Options, then restart the flight if the active session does not refresh.
- Developer visualisation is active: If many short lines surround the rotor rather than pointing towards a destination, disable the active aerodynamic or CFD debug display, or turn off Developer Mode under General Options.
Is the line controlled by helicopter assistance settings?
Normally, no. Assisted Cyclic and Assisted Tail Rotor alter helicopter handling; they do not control the usual route, landing or taxi guidance overlays. Keep them enabled if you want the stabilising help but not the lines.
If handling assistance is the actual problem, our helicopter controls and assistance setup covers the relevant axis and aid choices. A coloured course line shown only on a Garmin unit or other cockpit display is also separate: that is an avionics flight-plan indication, not an external guidance overlay.